Displaying Snmp Settings - 3Com LANPLEX 6000 User Manual

3-20 C 3: C
HAPTER ONFIGURING
Displaying SNMP
Settings
Top-Level Menu
system
ethernet
display
fddi
mode
tokenring
community
bridge
trap
ip
snmp
analyzer
script
logout
M A
ANAGEMENT CCESS
Set the SNMP mode to multipleAgent.
For directly managed agents, set the destination IP address(es) of the
management station(s) where traps should be forwarded by each agent.
For indirectly managed agents, set the destination agent through which
traps should be proxied.
For indirectly managed agents, find the community strings needed for
proxy in lpsSnmpInternalProxyTable located in the LANplex Systems MIB.
You can display the current LANplex SNMP configurations for the SNMP
mode and community strings.
To display SNMP settings, enter the following from the top level of the
Administration Console:
snmp display
If the system is set for the single agent SNMP mode, the mode setting and
community string values for the agent are displayed as shown in the
example below:
Current SNMP mode is singleAgent
Read-only community is public
Read-write community is private
If the system is set for multiple agent SNMP mode, the mode setting and
community string values for each agent (by slot) are displayed as shown in
the following example:
Current SNMP mode is multipleAgent
Slot 1 - Chassis
Read-only community is public
Read-write community is private
Slot 2 - ESM
Read-only community is public
Read-write community is private
Slot 3 - EFSM
Read-only community is public
Read-write community is private
The SNMP trap configuration display is available with the trap menu.
T T S
O HE YSTEM