Configuring Arp Source Mac Address Consistency Check; Displaying And Debugging Arp; Arp Configuration Examples - 3Com 4500 Configuration Manual

The sending of gratuitous ARP packets is enabled as long as an S4500 switch operates. No command
is needed for enabling this function. That is, the device sends gratuitous ARP packets whenever a
VLAN interface is enabled (such as when a link is enabled or an IP address is configured for the VLAN
interface) or whenever the IP address of a VLAN interface is changed.

Configuring ARP Source MAC Address Consistency Check

To do...
Enter system view
Enable ARP source MAC
address consistency check

Displaying and Debugging ARP

To do...
Display specific ARP mapping
table entries
Display the ARP mapping
entries related to a specified
string in a specified way
Display the number of the ARP
entries of a specified type
Display the statistics about the
untrusted ARP packets
dropped by the specified port
Display the setting of the ARP
aging timer
Clear specific ARP entries

ARP Configuration Examples

Network requirements
Disable ARP entry check on the switch.
Disable VLAN-interface 1 of the switch from sending gratuitous ARP packets periodically.
Set the aging time for dynamic ARP entries to 10 minutes.
Add a static ARP entry, with the IP address being 192.168.1.1, the MAC address being
000f-e201-0000, and the outbound port being Ethernet 1/0/10 of VLAN 1.
Use the command...
system-view
arp anti-attack valid-check
enable
Use the command...
display arp [ static | dynamic | ip-address ]
display arp [ dynamic | static ] | { begin |
include | exclude } regular-expression
display arp count [ [ dynamic | static ] [ |
{ begin | include | exclude }
regular-expression ] | ip-address ]
display arp detection statistics interface
interface-type interface-number
display arp timer aging
reset arp [ dynamic | static | interface
interface-type interface-number ]
1-6
Remarks
—
Required
Disabled by default.
Remarks
Available in
any view
Available in
user view