Setting To Output System Information To The Trap Buffer - 3Com 4200G 12-Port Configuration Manual

To do...
Enter system view
Enable the information center
Enable system information
output to a log host
Configure the source interface
through which log information is
sent to the log host
Configure the output rules of
system information
Set the format of the time
stamp to be sent to the log host
Be sure to set the correct IP address when using the info-center loghost command. A loopback IP
address will cause an error message prompting that this address is invalid.

Setting to Output System Information to the Trap Buffer

Follow these steps to set to output system information to the trap buffer:
To do...
Enter system view
Enable the information center
Use the command...
system-view
info-center enable
info-center loghost
host-ip-addr [ channel
{ channel-number |
channel-name } | facility
local-number ]*
info-center loghost source
interface-type interface-number
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity | state
state } ]*
info-center timestamp
loghost { date | no-year-date |
none }
Use the command...
system-view
info-center enable
1-12
Remarks
—
Optional
Enabled by default.
Required
By default, the switch does not
output information to the log
host.
After you configure the switch
to output information to the log
host, the switch uses
information channel 2 by
default.
Optional
By default, no source interface
is configured, and the system
automatically selects an
interface as the source
interface.
Optional
Refer to Table 1-4 for the
default output rules of system
information.
Optional
By default, the time stamp
format of the information output
to the log host is date.
Remarks
—
Optional
Enabled by default.