Using Objet Studio
Setting the
Printer
Connection
5–60
When an Objet 3D printer is installed, the server computer is connected to
that printer. Normally, there should be no reason to change this connection.
Occasionally, however, you may need to reset the connection, to connect
the server to another printer, or to use Objet Studio in off‐line mode
(without a printer connection).
To set (or change) the printer connection:
1. On the Job Manager ribbon, in the 3D Printer group, click
2. In the Set Printer dialog box, click
Figure 5-85: Connecting to a printer (A)
3. Enter the computer name or its IP address, or click
select it.
Figure 5-86: Connecting to a printer (B)
4. Click
.
OK
When the connection is established, Objet Studio is configured to
prepare print jobs for that printer.
Objet Studio is connected to the printer if you can see the material levels in
the Job Manager screen (see figure 5-84 on page 57).
.
Connect
Browse
.
to find and
DOC-24333 Rev. A