Setting The Remote Printer Connection (Client Mode); Job Manager Commands; Ribbon Commands 5 - Stratasys Objet1000 Plus User Manual

Objet1000 Plus User Guide
Setting the When you open Objet Studio for the first time in a client installation, you are
Remote Printer prompted to connect to a server computer that sends jobs to a 3D printer. To
Connection do this, the server computer must be operating and connected to the local
(Client Mode) network.
To set (or change) the connection to the server-computer:
1. On the Job Manager ribbon, in the 3D Printer group, click
2. Enter the name of the server computer or its IP address, or click Browse
3. Click OK.
The Job Manager ribbon has three icon groups:
Job Manager
Commands
Icons are enabled or disabled according to their relevancy. For example, since
you cannot stop printing a job that is not being printed, the Stop command is
disabled when the printer is idle.
DOC-06810 Rev. B
to find and select it.
Figure 5-102 Printer Server Connection dialog box
❒ 3D Printer
❒ Queue
❒ Job
Figure 5-103 Job Manager ribbon commands
5 Using Objet Studio
.
5-77