Error Messages - Christie G Series Application Manual

Message Element
Function code
+subcode
Request and reply symbols

Error Messages

If a command cannot be performed, a descriptive error identifying the problem appears. For
example, this message indicates a syntax error:
(ITP) - (65535 00000 ERR00005 "ITP: Too Few Parameters")
G Series Serial Commands Application Guide
020-000578-02 Rev. 1 (01-2014)
The primary projector function being queried or modified. Each function code is
represented by a three-character, upper or lower case ASCII code (A-Z).
The function code appears after the first parenthesis. If a command does not
include a subcode, a space between the function code and the first parameter (or
special character) is optional.
The secondary projector function being queried or modified.
Each subcode is represented by a four-character, upper or lower case ASCII code
(A-Z and 0-9). The subcode appears after the function code, and it is separated
from the function code with a plus symbol (+). If a subcode is not included, the
plus symbol is not required.
If a command includes a subcode, a space between the subcode and the first
parameter (or special character) is optional.
The question mark symbol (?) appears after the function code when the controller
requests projector information.
An exclamation mark (!) appears after the function code when the projector
responds to a request.
Do not include a question or exclamation mark when creating a
Communicate with the Projector
Description
command.
SET
4