Error Messages; Descriptive Error - Christie Mirage SST Technical Reference

Message Description
requirement
the end code bracket. Make sure to add a space before the calculated checksum to
separate it from the last data parameter:
The checksum is the low byte of the sum of the ASCII values of all characters between the
start bracket and the beginning of the checksum, but not including either. It does include
the space in front of the checksum.
Calculate the checksum for the above set contrast to 64 command as follows:
CHECKSUM EXAMPLE = & + c + o + n + 6 + 4 + 'space'
Mirage SST collects all of the message bytes as defined in the first byte of the message,
then creates its own checksum value for comparison with the checksum included in the
controller's message. If the values match, the message is considered to have been
correctly received; otherwise, the message is discarded.
Note the following:

Error messages

If a command cannot be performed, a descriptive error identifying the problem appears.
For example, the following message indicates a syntax error:
(ITP) - (65535 00000 ERR00005 "ITP: Too Few Parameters")

Descriptive error

The following error codes indicate a problem if a command cannot be performed.
Error code Description
3 Invalid parameter
4 Too many parameters
5 Too few parameters
6 Channel not found
7 Command not executed
8 Checksum error
9 Unknown request
10 Error receiving serial data
Mirage SST Technical Reference–Serial Commands
020-103005-03 Rev. 1 (01-2021)
Copyright © 2021 Christie Digital Systems USA, Inc. All rights reserved.
= 26h+63h +6Fh +6E h +36h +$34h +$20h
= 01F0h
= F0h when only the low byte is used
= 240
• h indicates a hex number.
• If a request message has a checksum, so does the reply.
• If using both acknowledge and checksum, either character can occur first.
Communicating with Mirage SST
Error code Description
105 Disabled control
106 Invalid language
107 Exceeded list size
110 Communication timeout
111 Communications failure
112 Failed to set hardware
113 Bad file
114 Memory failure
13