Table of Contents
Advertisement
Section 3: Operation
3.1.14 Status Display (Error Codes) and Status Display Window
Two-digit Status/error Code Window
This LED (light emitting diode) display is adjacent to the built-in keypad. During normal operation, the
"POWER" light is steady yellow and indicates "ON". When the status of the projector changes, the LED
displays a 2-digit code number representing the projector's new status. In addition to the numeric readout, there
are 2 decimal points in the display: the right decimal point flashes when the projector receives a command and
the left point flashes when the projector sends a command.
LCD Status Display Window
Displays a text message describing the current system status (such as an error). During normal operation, this
display indicates Power ON and includes the frequencies of the vertical and horizontal syncs. The display also
shows if the On Screen Display (OSD or Menu system) is ON or OFF. The LCD displays the message "Power
Off" when the breaker is ON, but the lamp is OFF.
3.1.15 Keypads / Sensors
Wired Remote Connector
For optional tethered remote control of the projector.
Built-in Keypad
Alternative location for working with the projector.
Infrared Sensors
The infrared (IR) sensors on the front and rear of the projector receive infrared signals from the IR remote
which remotely controls the projector's functions. For proper operation, ensure these sensors are not blocked.
3.2
Using the Keypads
the beam of the remote.
Using one of the following keypads typically controls the projector:
• The Built-in keypad
• The Remote keypad
remote)
While the built-in keypad or standard IR remote provides complete control of the projector, they differ slightly
in their arrangement of keys, and in which functions can be accessed directly with a key press rather than
requiring use of the Menu system. You may find one keypad more convenient than another for your specific
installation and application.
NOTE: The remote keypad has a single IR protocol and can be converted to a wired remote by connecting the
cable provided with the projector to the RCA jack labeled as REMOTE on the input panel.
3-4
Laser radiation is emitted from the laser diode in the remote. Do not look directly into
(Figure
3-2) located at the rear of the projection head
(Figure
3-3) for tethered or tether-less control (includes cable for connecting as a wired
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1 (04-2011)
Advertisement
Table of Contents
