Advanced: Lamp Menu - Christie CP2000-ZX User Manual

Advanced: Lamp Menu

The Advanced: Lamp menu provides controls for optimizing lamp alignment (LampLOC™), maintaining a
consistent light output over time (LiteLOC™), or setting a precise power level for the lamp. Two read-only
areas display related lamp performance details - the side bar graph represent the current light output and, if
LiteLOC™ is enabled, a heavy line showing the chosen LiteLOC™ setting.
Lamp power range -
™
adjustable if LiteLOC
is not in use. See Table
3.11 for lamp power
ranges.
Set and maintain consis-
tent light output as
indicated by the value
listed in text region to
the right.
Position lamp for best
light output.
x = horizontal
y = vertical
z = forward / back
™
Auto LampLOC
adjustment.
Table 3.14 Summary of Advanced: Lamp Menu Options
ADVANCED: LAMP MENU OPTIONS
Lamp Power
Enable
Set (Brightness)
LampLOC™
Lamp (Read Only)
Light (Read Only)
CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)
™.
Enable LiteLOC
Figure 3-26 Advanced: Lamp Menu Options
Indicates the percentage of power to supply to the lamp and automatically overrides the LiteLOC™
setting that may be in effect. Please refer to Table 3.11 for the valid Lamp Power ranges for specific
lamp types. Adjusting the Lamp Power causes the bar graph to rise or fall as Lamp Power increases
or decreases. The LiteLOC™ red line and Lamp values will not change unless Set is clicked. This
defines a new LiteLOC™ setting and enables the LiteLOC™ checkbox. Lamp Power is enabled only
when LiteLOC™ is disabled, by de-selecting the Enable button.
Click Enable to use LiteLOC™ for the current channel based on the value in the text box to the right
of the Set button.
Automatically enables LiteLOC™ and maintains the current brightness level (shown in the Lamp
region) as long as possible. Arbitrary units-of-measure shown in the text region to the right of the Set
button, not lumens or fL.
LampLOC™ buttons activate motors that reposition the bulb in the projector for optimized light out-
put. Click Do Auto (recommended) or the individual buttons. NOTES: 1) Lamp must be ON to
begin. If it is turned off during a re-positioning, the bulb will return to its former position. 2) Douser
opens and remains non-functional during a LampLOC™ adjustment.
Indicates the current lamp amps (amps), voltage (volts), watts (lamp power) and age (hours).
This is a meter reading from the projector's light sensor. Indicates the current light output (vertical
bar) and LiteLOC™ level set (red horizontal line). The value at the top of the meter is shown in arbi-
trary units-of -measure and does not represent actual lumens or fL.
Section 3: Operation
Read-only lamp informa-
tion.
Reading from light sensor.
Red bar indicates Lite-
™
LOC setting (desired
brightness).
Light output.
3-33