Navigating The Cdp Menus; Icons; Pull-Down Lists - Christie CP2000-ZX User Manual

3.3.2 Navigating the CDP Menus

Most basic controls of the projector are accessed from within the projector's menu
system. There are several groups of related functions with each group selectable as
a menu item in the Main menu as shown in the figure to the right. Press
any time to display the Main menu. With the Main menu displayed, use the arrow
keys to highlight the desired option, then press
corresponding function menu or pull-down list of further options will then appear.
Extra long menus are indicated by a small arrow in the bottom right corner of the
display. To scroll through a list of items, use the down arrow key. Once past the
four line limit of the display, another arrow will appear in the upper left corner to
allow scrolling of the menu in both directions.
Press once when you want to return to the previous level of options.
EXIT
Other navigation icons used in menus are as follows:

Icons

Various status icons are used in the CDP display to convey projector status. With the exception of the status
icon, all other CDP icons will appear on the display as the functions are enabled or disabled.
Icon
Status
Service
Power
Error
Lamp On
Lamp Off
Douser Open
Douser Closed

Pull-Down Lists

Press to see a pull-down list of options available for a given parameter. Then use the arrow keys to
ENTER
scroll through a list of options or to adjust settings. Press
CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)
Additional menu items available, press
view.
Menu option is enabled (ON).
Menu option is disabled (OFF).
Description
This icon always appears in the upper right hand corner of the CDP display to indi-
cate the communication status of the projector. When flashing, active communica-
tion is taking place. When solid, it can mean that communication is temporarily
stalled (i.e. too many keypresses entered at one time) or that communication with
the projector has failed.
This icon appears on the CDP display whenever the following functions are ON:
Lamp Change, Lamp Rotation or Filter Change.
This icon appears on the CDP display when power to the projector is in "power on"
mode (not in standby).
This icon appears on the CDP display whenever a critical error occurs.
This icon appears on the CDP display when the lamp is ON.
This icon appears on the CDP display when the lamp is OFF.
This icon appears on the CDP display when the douser is OPEN.
This icon appears on the CDP display when the douser is CLOSED.
to make your selection. The
ENTER
to
ENTER
while in a pull-down list to cancel.
EXIT
Section 3: Operation
CP2000-ZX Menu
=====
at
Channel
MENU
Lamp
Lens Control
Status
Configuration
Test Patterns
Figure 3-2 CDP Main
Menu Options
=====
3-7