Christie CP2000-ZX User Manual page 152

Appendix A: Serial API
Projector Platform and Motherboard-related Information (SYS)
DESCRIPTION - Stores the projector platform and motherboard related information.
SUBCODE DESCRIPTION OF USE
MCBI 0/1 - Set software flag to use/not use ILS on CP2000-ZX.
MOTH Read motherboard revision of the projector.
PLAT Read platform ID of the projector.
EXAMPLES:
(SYS+PLAT?) Gets the platform of the projector.
(SYS+MOTH?) Gets the motherboard revision of the projector.
(SYS+MCBI 1) Set flag to use ILS on CP2000-ZX.
Target Color Gamut (TCG)
DESCRIPTION - Set the Target Color Gamut file. This file describes desired output colorimetry from the projector. For this
control to function the Measured Color Gamut Data must be accurate.
SUBCODE DESCRIPTION OF USE
Cxxx Replace xxx with the channel number. Valid Range is 101 - 164.
NONE Select target color gamut for the current channel.
RFSH Set (1) to refresh files, 0 do nothing
TEMP Select the target color file as DLP active file, do not change channel settings.
EXAMPLES:
(TCG+C108 "Altanis") Use file "Altanis" on channel 108
(TCG+C108? ) Get target color file name on channel 108
(TCG?L) List all available entries of target color control
(TCG+TEMP "Altanis") Use file "Altanis" as DLP active file
(TCG+RFSH 1) Refresh TI file list
Enable 3D (TDC)
DESCRIPTION - Enable/Disable 3D on the specified channel. This controls the frame rate multiplication features that allow
for simulated three dimensional image projection.
SUBCODE DESCRIPTION OF USE
Cxxx Replace xxx with the channel number. Valid Range is 101 - 164.
None Select 3D enable for the current channel
EXAMPLES:
(TDC+C108 1) Enable 3D on channel 108
(TDC+C108?) Get 3D setting on channel 108
(TDC?) Get current 3D status
A-24 CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)