Intelligent Lens System (Ils); To Enable Ils Per Channel; To Edit Active Channel Ils Settings; To Temporarily Alter The Active Channel Ils Settings - Christie CP2000-ZX User Manual

Section 3: Operation

Intelligent Lens System (ILS)

The ILS button launches a control screen used to adjust the Focus, Horizontal (X) and Vertical (Y) Offset, and
Zoom of the lens. See Figure 3-9. All settings on this screen are in real-time. This menu also enables you to
manually override the intelligent lens system settings.
When the channels are changed, the ILS automatically moves the lens to adjust the focus, Horizontal (X) and
Vertical (Y) offset, and zoom based on the pre-defined settings. All manual override settings are lost. This
feature should only be used to make quick changes. Proper adjustments should be made in the Channel: Lens
menu when time permits.
When ILS is enabled (Automatic ILS is checked) and the channel has been specified, it begins adjusting each
motor. The proper lens type must be selected from the Advanced: Lens menu beforehand. The position of
each motor is then saved onto the system in the specific channel file. This is not a global feature - instead it is
controlled on a per channel basis. When this feature is enabled, the ILS for the currently selected channel is
turned ON. NOTES: 1) Using the knobs on the lens mount to adjust these positions does not save the settings
to the channel. They are designed for temporary use and will therefore be lost once the channel changes. 2)
Only Advanced users can modify channel settings. 3) Keep clear of rotating parts. Remotely operated motors
may start to spin without warning. 4) In case of emergency, unplug the line cord to immediately halt movement
of the lens mount.

To Enable ILS Per Channel

1. From the Main menu, select one of the available channels.
2. Enable Test Patterns checkbox to select a test pattern.
3. Select the ILS button from the Main menu to launch the ILS
screen (Figure 3-9).
4. Select Automatic ILS to automatically apply the per
channel settings.

To Edit Active Channel ILS Settings

1. Ensure Automatic ILS is checked.
2. Adjust the focus, Horizontal (X) and Vertical (Y) offset or
zoom one step at a time by clicking the applicable button or hold the button down for continuous
movement. If you hold a button down, a Pending message will display until you release the button. NOTE:
This over-writes the intelligent lens system settings.

To Temporarily Alter the Active Channel ILS Settings

1. De-select the Automatic ILS checkbox.
2. Adjust the focus, Horizontal (X) and Vertical (Y) offset, and zoom. NOTE: This does not over-write the
system settings for the ILS.
3. To revert back to the ILS settings, check Automatic ILS.

Start Features or Presentations

To start a different feature or presentation, click its corresponding display Channel button. NOTE: By clicking
a channel button, test patterns are automatically turned OFF to present show content.
3-16
Figure 3-9 Intelligent Lens System
CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)