Christie CP2000-ZX User Manual page 147

Serial Port (PRT)
DESCRIPTION - Get a list of serial ports available on the device.
SUBCODE DESCRIPTION OF USE
NONE NONE
EXAMPLES:
(PRT?1) Get list of ports
Power (PWR)
DESCRIPTION - Change the power state of the projector. Data can be:
3 - Power OFF - all electronics power OFF except Projector Control Module (PCM). It's also called standby mode.
1 - Power ON - projector is powered ON with lamp ON
0 - Full power mode - projector is ready for lamp ON.
11 - Warm up. Read only, it's middle status between standby and full power mode.
10 - Cool down. Read only, projector will stay in cooling down mode for 15 minute after lamp is turned OFF.
SUBCODE DESCRIPTION OF USE
COOL Read only status of current cooling down timer.
NONE Select power state.
STAT Read only Status of current power state.
EXAMPLES:
(PWR+STAT?) - Get projector power status
(PWR+COOL?) - Get how many seconds left on cooling down mode
(PWR3) - Set the projector to standby mode
(PWR0) - Turn the projector ON and lamp OFF
(PWR1) - Turn the projector ON and lamp ON
(PWR?) - Get the last command sent to projector (target power state)
Table A.2 Projector Power Modes
NOTES: 1) The green status LED flashes while the yellow LED is on steady while in "Boot Delay". 2) Both green and yellow status LEDs flash during "Cool
Down.
CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)
Appendix A: Serial API
A-19