Configuration Menu - Christie CP2000-ZX User Manual

Section 3: Operation
Lens Reset
The Lens Reset feature automatically moves the lens to a central location (mechanical center) before moving
back to the original position. This feature is useful for initiating an auto lens reset. Each motor can either be
reset individually or select All Axes to reset the four motors in succession. When Idle is active it indicates
Lens Reset is currently inactive. Typically, the lens must be reset if it has been physically bumped, when
manual adjustments have been made to zoom and focus, or if a power outage or brown-out occurred during a
channel change. NOTE: Idle must be inactive in order for Lens Reset to work.
Auto ILS
Auto ILS is a per channel setting that is stored with the channel so that when a channel is made active the lens
will automatically move to the saved or default position agreed to that channel. If Auto ILS is inactive, a
manual adjustment of the lens is required and any channel change will not adjust the lens.
Lens Calibration
Since the CP2000-ZX can accommodate a number of different lenses, which all contain specific motor travel
ranges, it is essential that lens calibration be performed each time a lens is installed. Calibration is critical for
lens accuracy - it corrects system backlash and detects motor range for the installed lens. Typically, the lens
must be calibrated when a new or different lens has been installed, when the lens mount has been replaced or if
ILS settings are drifting within a short period of time. Once lens calibration is completed, the results for the
current lens are saved to the system. To adjust individual motors, select from Focus, Zoom, Vertical and/or
Horizontal. To calibrate all motors in sequence select All Axes. When Idle is active it indicates lens
calibration is currently inactive. NOTE: Idle must be inactive in order for Lens Calibration to work. When
changing lenses, you must select the lens from the Lens Table in the Advanced: Lens menu and then perform
a lens calibration. This will adjust the ranges so that you get full range use for the selected lens.

Configuration Menu

The Configuration menu provides controls for adjusting the contrast and
brightness settings of the CDP, run diagnostic controls, select the use of the
auxiliary lens as well as provide you with controls to define and change
various Ethernet settings, such as the projector's network address.
Similar controls are also available through the web user interface. Refer to
Section 3.4.4 Status Menu
Warning! Never run Interrogator during a show as this could cause image
disruption. Refer to
Administrator controls available through the web user interface.
3-10
for a description of Interrogator controls.
Section 3.4.8 Admin Menu for description of similar
Configuration
====
====
CDP Contrast
CDP Backlight
Interrogator
Interrogator ++
Administrator
SCCI Control
Figure 3-6 CDP
Configuration Menu Options
CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)