Lamp Menu - Christie M Series User Manual

Section 3: Operation
PIP BORDER WIDTH
Enables the optional border around the PIP image. When enabled, a one pixel-wide border will surround the
PIP image. When disabled, no border will be displayed.
PIP BORDER COLOR
This control allows you to choose the color of the optional border around the picture-in-picture image. The
border can be disabled by setting the width to zero.
FADE TIME
Sets the amount of time (in seconds) it takes to fade between images on a source switch and fades in the PIP
image.
FRAME LOCKING
This option allows the projector to control the output frame timing based on the input signal. The Frame Lock
option forces (if possible) the output image to be phase locked to the input frames. When Frame Locked, the
output is always locked to the primary input, and never to the PIP image. Free Run sets the output to run at a
fixed frame rate frequency. The frequency is defined by Free Run Frequency. By default, the free run
frequency is 59.94Hz.
to a new input with frame locking enabled, the image will be black for the short period while the system locks
onto the new input.
AUTO INPUT SEARCHING
When enabled, the system will continually search for the next valid signal when no signal is present or when
loss of sync occurs on the current user selected input. In the case of multiple signals to choose from, the order
is based on slot, followed by inputs on that slot.

3.10 Lamp Menu

LAMP OPERATION
Select the operational mode to be assigned to the
lamp(s) from the Lamp Operation drop-down list. If
a lamp fails to strike on the first attempt, you can
attempt upto 3 more strikes.
The Lamp Operation modes are:
• Lamp 1 single lamp use or Lamp 2 single lamp
use modes will only use the lamp specified. If the
selected lamp will not strike, then the projector
will not turn on. If the "Single Lamp Switch on
fail" option is enabled, the projector will always
attempt to turn on the selected lamp first, but if that lamp fails all attempts to strike, it will cause a switch to
the other lamp. This option is not enabled for DLV models, which are restricted to operate in Dual Lamp Use
mode only.
• Dual Lamp Use mode will use both lamps together. After 3 failed attempts to stay in Dual Lamp Use mode,
the projector will switch to Single Lamp operation; however, the user-selected mode remains as Dual Lamp
Mode.
3-52
Seamless switching is only available when free run is selected. When switching
NOTE:
Lamp
1. Lamp Operation
2. Lamp Mode
3. Lamp Power
4. Lamp Intensity
5. Yellow Notch Filter
6. Single Lamp Switch on Fail
7. Dynamic Iris
8. Warn when lamp reaches (hours)
9. Lamp 1 s/n
10. Lamp 2 s/n
11. Change Lamp
12. Lamp 1 History
13. Lamp 2 History
F 3-40 L
IGURE
Dual Lamp Use
Constant Power
370
50
N/A
N/A
M
AMP ENU
M Series User Manual
020-100009-04 Rev. 1 (10-2009)