Advanced: Lens Menu - Christie CP2000-ZX User Manual

Advanced: Lens Menu

The Advanced: Lens menu allows you to setup the primary lens, auxiliary lens and the ILS.
Primary Lens: Select the
lens type from the drop-
down menu.
Auxiliary Lens: Select
the lens type from the
drop-down menu.
Intelligent Lens System:
Calibrate ILS.
Table 3.16 Summary of Advanced: Lens Menu Options
ADVANCED: LENS MENU OPTIONS
Primary Lens
Auxiliary Lens
Save
Restore
ILS Installed
Lens Reset on
Startup
Calibrate
Lens Reset
CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)
Figure 3-28 Advanced: Lens Menu Options
From the drop-down menu, select the type of primary lens installed on the projector.
If an auxiliary lens is installed, select it from this drop-down list. The selections include anamorphic
and wide converter lens. This selection is grayed-out when there is no auxiliary lens connected.
Click to save the current serial number.
Cancel new (unsaved) settings and restore previous settings.
Enables/disables the Intelligent Lens System (ILS). NOTE: ILS Installed must be checked in order to
use the ILS functionality.
Select this checkbox for the ILS to locate the sensor flags and the backlash of each motor at the same
time. Keep checked if you need to reset the lens often.
Click Calibrate to calculate the amount of backlash for each motor and make the necessary adjust-
ments to ensure proper motor range. Calibration should only be used when changing lenses and is a
necessary step at that time.
When Lens Reset is clicked, the motors on the lens move to a central location (mechanical center)
before moving back to the original position. This feature is useful for initiating an auto lens reset. Each
motor can either be reset individually or select All Axes when prompted to reset the 4 motors in suc-
cession.
Section 3: Operation
Serial Number: Record the
serial number for the selected
primary lens.
Serial Number: Record the
serial number for the selected
auxiliary lens.
3-35