Christie CP2000-ZX User Manual page 149

Shutter/Douser (SHU)
DESCRIPTION - Open/Close shutter/douser
SUBCODE DESCRIPTION OF USE
None Select douser position 0 - douser removed from optical path 1 - douser blocking optical path
STEP Change the steps for open/close douser on CP2000-ZX. The default value is 50.
EXAMPLES:
(SHU 1) Close shutter
(SHU 0) Open shutter
(SHU?) Get current status of shutter
Select Input (SIN)
DESCRIPTION - Select Input Port. Selecting input port will reset the list and default data of DTF control. Use index number
or text description to select input port. NOTE: Available options are: 00000 "292-A") 00001 "292-B") 00002 "292-Dual")
00003 "DVI-A") 0005 "DVI-Twin")
SUBCODE DESCRIPTION OF USE
Cxxx Replace xxx with the channel number. Valid Range is 101 - 164.
NONE Select input for current channel
EXAMPLES:
(SIN?) Get current input port
(SIN?L) Show entries on the list
(SIN 1) or (SIN "292-B") Set current input port to 292-B
(SIN+C101 ?) Get input port on channel 101
(SIN+C101 1) or (SIN+C101 "292-B") Set input on channel 101
SNMP Agent Configuration (SNM)
DESCRIPTION - This control will set the various configuration options for SNMP Agent
SUBCODE DESCRIPTION OF USE
ENVT Enables/Disables SNMP version 2
LEXT Gets/Sets the Lamp Expire Trap Flag for the SNMP Agent
LHLT Gets/Sets the Lamp Half Life Trap Flag for the SNMP Agent
TSIP Sets the Trap IP address for the SNMP agent
EXAMPLES:
(SNM+TSIP "xxx.xxx.xxx.xxx") Sets the Trap IP address to xxx.xxx.xxx.xxx
(SNM+TSIP "0.0.0.0") Setting the IP address to 0.0.0.0 will stop SNMP Agent from sending the traps.
(SNM+LHLT 1) Setting this flag to 1 will disable any future lamp half life traps
(SNM+LEXT 1) Setting this flag to 1 will disable any future lamp expire traps
(SNM+ENVT?) Get the flag to see if V2 is enabled (1) or disabled (0)
(SNM+ENVT 1) Enable SNMP V2
(SNM+ENVT 0) Disable SNMP V2
CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)
Appendix A: Serial API
A-21