Lamps; Lens Mount And Motorized Auxiliary Lens Mount; Security Locks; Source And Communication Panel - Christie CP2000-ZX User Manual

3.1.6 Lamps

The CP2000-ZX can be used with either a 2.0kW or 3.0kW lamp, which is located on the non-operator's side
of the projector (right side).
Table 3.1 Lamp Type
Type
2.0 kW CDXL-20
3.0 kW CDXL-30
3.0 kW CDXL-30SD
The lamp door must remain closed and locked for all normal operation. Only trained operators can access the
lamp via a security key.

3.1.7 Lens Mount and Motorized Auxiliary Lens Mount

The lens mount secures and seals a primary zoom lens within the projector and provides automatic adjustments
of focus, zoom and offset. Adjacent to the primary mount is an optional auxiliary lens mount that may be
added providing for positioning a 1.25x Anamorphic lens or a 1.26x Wide Converter lens in front of the
primary lens. The Wide Converter lens "zooms" the image from flat to scope image formats. The Anamorphic
lens horizontally spreads the image back into its wider 2.39:1 "scope" image and is most typically used in side-
masking theatres or on larger screen sizes.

3.1.8 Security Locks

Critical internal components and/or connections are protected by various security locks on projector covers/
access panels. The projector's panels cannot be removed with standard tools unless the key locks are open.
This safeguard enables only authorized personnel to access and service components in these restricted areas.
Panels with high-security lock: Front Optical Access Panel (top)
Panels with mid-security lock: Lamp Door
No locks: Air Filter Access Panel, Projector Control Module Input Panel

3.1.9 Source and Communication Panel

Projector Control Module (PCM) located on the right hand side of the projector. Located on the operator's side
of the projector (left side) is a communication panel that provides connection of external devices such as
servers and a controller. The eight ports on the panel include:
• Management Ethernet- Connect to this 10/100 Ethernet port for control, key management, subtitles,
etc. Since both ports are part of an Ethernet switch, each port can be used interchangeably or two devices
can be connected simultaneously. The IP address of the projector can be found from the CDP under Status
> Config Status > Mgmt IP address.
• RS232 B - Utilizes Christie-proprietary protocol and is intended for Christie accessories or automation
controllers only.
• Service - Ethernet port to be used only by Service personnel.
• DVI-D A and DVI-D B ports - Connect a variety of non-cinema video and graphics sources to either of
these identical single-link DVI ports. These are single-link ports for single-link cables/connectors only.
Using this dual-link pair of ports requires a special adapter.
CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)
Description
Section 3: Operation
3-3