Connecting For Communications - Christie CP2000-ZX User Manual

2.2.1 Connecting for Communications

Many communications with the projector are initiated on the CDP controller, which is mounted at the rear of
the projector. Depending on the installation, you may also need certain other serial and/or Ethernet links to the
CP2000-ZX, such as from a server or PC functioning as a controller, or from an existing on-site network
including other equipment. For applications or equipment utilizing serial communications, use the Christie-
proprietary serial protocol to connect to the RS232 B port on the PCM (Figure 2-17
port located on the PCM utilizes Christie-proprietary protocol and is intended for Christie accessories or
automation controllers only. Do not connect other devices here.
Control Display Panel (CDP)
The CDP comes pre-installed and does not require further connection.
PC/Laptop, Server or Network
To communicate with the projector from a computer, server or an existing network, connect the equipment to
the Ethernet hub or switch at your site.
CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)
Figure 2-17 Communication Links with Projector
Section 2: Installation & Setup
).
Caution! The RS232 B
PWR CPU
2-13