Christie CP2000-ZX User Manual page 95

3. DEFINE THE 3D SYNC INPUT MODE:
For dual inputs,
• Set 3D Sync Input Mode to Active Port: A/B = L/R or vise versa
This setting tells the rest of your system that incoming 3D stereo sync information is included with the two
L/R image data inputs rather than routed separately to the GPIO port.
For future single-input 3D sources where the server supplies a separate 3D stereo sync to the projector's
GPIO port instead, set Sync Input according to the input # used (i.e. according to your GPIO cable wir-
ing.)
4. DEFINE L/R DISPLAY SEQUENCE:
• Set L/R Display Sequence to Right (R1L1R2L2) or vise versa
5. DEFINE SYNC OUTPUT:
• Set 3D Sync Polarity to inverted. NOTE: If the display appears reversed, i.e. background appears
close and foreground appears at a distance, you will need to make sure that the cable connecting server
output A is connected to projection input A and the cable connecting server output B is connected to pro-
jection input B.
CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)
Figure 3-50 Setup for 3D
Section 3: Operation
3-57