Christie CP2000-ZX User Manual page 130

Appendix A: Serial API
Table A.1 Function Codes
Address (ADR)
DESCRIPTION - Set/Query Device Address on ASCII Protocol network. Required only for RS - 232 connections that are
daisy chained to allow directed messages.
SUBCODE DESCRIPTION OF USE
None Valid Address range is 0 to 999. Reserved broadcast address is 65535.
EXAMPLES:
(0 ADR 5) Set first device with an address of 0 to 5.
(65535 ADR 0) Set all devices to address 0.
(65535 1001ADR ?) Query address for all devices and return results to address 1001.
Expected response to previous query (01001 00005ADR!005).
Auxiliary Motorized Lens (AML)
DESCRIPTION - Control the motorized auxiliary lens (anamorphic or converter lens).
SUBCODE DESCRIPTION OF USE
CALI 1, Send command to find the center position of the sensor for MALM.
CSTA 0-100%, read-only command for returning the status of MALM calibration.
Cxxx Replace xxx with channel number. Range from 101 - 164.
INST 0-1, the flag to indicate if MALM is installed.
LENI steps, The steps to move MALM to lens in position where (AML1) is set
LENO steps, The steps to move MALM to lens out position where (AML0) is set
MAXS Read-only command, gets the maximum speed to move MALM by FPGA
MINS Read-only command, gets the minimum speed to move MALM by FPGA
NONE Set auxiliary lens position 0 - lens removed from optical path 1 - lens inserted in optical path
POSI Read-only command which returns where MALM is located
EXAMPLES:
(AML?) Get the current status of auxiliary lens
(AML+C108 1) Use auxiliary lens on channel 108.
(AML+C108?) Query auxiliary lens setting for channel 108.
(AML+C108!001) Response form previous query.
(AML+INST 1) Set flag for using MALM, otherwise MALM is ignored
(AML+LENI -300) Move lens to -300 for lens in position
(AML+LENO 6000) Move lens to 6000 for lens out position
(AML+POSI ?) Query where the lens is
(AML+CSTA ?) Query how much percent the MALM calibration is running
A-2 CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)