Non-Cinema Operation; Selecting A Source - Christie CP2000-ZX User Manual

Section 3: Operation

3.10 Non-Cinema Operation

This subsection explains how to display alternative content originating from standard definition or high
definition non-cinema sources such as a PC or other graphics devices.
Connect your non-cinema DVI source to the DVI-1 and DVI-2 ports. Each DVI port accepts and will auto-
detect the progressive scan, digital RGB sources (Table 3.25) displaying them in their original incoming
format. Currently, DVI signals cannot be scaled to a different size and/or aspect ratio. NOTE: Each DVI port is
a single-link port for a single-link cable/connector only. Using this pair of ports as a higher-bandwidth dual-
link or twin-link pair requires additional hardware and is not currently supported.
Table 3.25 Compatible Non-Cinema DVI Sources
Incoming
Format
1024 x 768
1280 x 1024
1400 x 1050
1920 x 1080
1920 x 1080
2048 x 1080
2048 x 1080
NOTE: Also compatible with HDCP-encrypted DVI signals.

3.10.1 Selecting a Source

For any display, the projector interprets incoming signal data according to one of 64 user-selectable display
files defined at the time of installation (or with each subsequent release of a new digital cinema feature) and
stored in projector memory. Each file is essentially a collection of processing/display settings optimized for a
particular cinema feature or non-cinema content, which enables consistent presentations with minimum further
adjustment. Each file is represented by an assigned "channel button" selectable over several pages of the Main
menu from the web user interface. Depending on your installation, you may have 0-64 different non-cinema
sources defined for use. For more information, refer to
SELECT A NON-CINEMA SOURCE
cinema source display button from the Main menu or by scrolling through a
selected, the projected display changes according to the corresponding file settings.
RETURN TO A CINEMA SOURCE:
input at port 292A or 292B from either the Main menu or from the
the DVI ports and responds to the cinema source selected.
3-62
Vertical Processing Path
Required
Frequency (Hz)
23-85 Hz Non-cinema
23-85 Hz Non-cinema
23-60 Hz Non-cinema
23-48 Hz DLP Cinema
23-62 Hz Non-cinema
23-48 Hz DLP Cinema
23-58Hz Non-cinema
: With a non-cinema source connected to the projector, select the desired non-
Select one of the cinema display buttons pre-configured for a cinema source
Section 3.4.3 Main Menu.
CHANNEL LIST
CHANNEL LIST
on the CDP. Once
—the projector now ignores
CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)