Channel: Lens Menu - Christie CP2000-ZX User Manual

Section 3: Operation

Channel: Lens Menu

This menu is used to modify the Intelligent Lens System settings for a particular channel. Adjust the Focus,
Horizontal (X) and Vertical (Y) Offset, or Zoom by clicking the respective buttons in a step-wise manner or
holding the button down for continuous movement. You may experience a slight delay in the response rate of
the lens upon selecting the buttons. Position values on the menu will change in real-time. When holding down
a button for continuous movement, the lens will begin to accelerate until the maximum velocity is reached. A
pending message appears on screen. NOTES: 1) Using the knobs on the lens mount to adjust these positions
does not save the settings to the channel. They are designed for temporary use and will therefore be lost once
the channel changes. 2) Only Advanced users can modify channel settings. 3) Keep clear of rotating parts.
Remotely operated motors may start to spin without warning. 4) Avoid long hair, jewelry, and loose clothing
exposure to the knobs during manual adjustment. 5) In case of emergency, unplug the line cord to immediately
halt movement of the lens mount.
the MALM to the OUT position before performing any lens calibrate or reset functions on the
Motorized Primary Lens Mount to prevent collision between the projection lens and the
MALM. 2) Hazardous moving parts. Keep fingers and other body parts away.
To adjust ILS settings for a particular channel:
1. Select a channel from the drop-down list.
2. Use the designated buttons to adjust Focus, Horizontal (X) and Vertical (Y) Offset, and Zoom.
3. Click Activate to save the settings to the particular channel.
Activate: Enabled
when active channel
selected.
Displays current
channel.
Focus: Use the but-
tons to adjust focus.
Offset: Use the but-
tons to adjust XY
offset.
Copy Lens Settings:
Use this feature to
copy specific lens set-
tings over to multi-
ple channels.
Table 3.12 Summary of Channel: Lens Menu Options
CHANNEL: LENS MENU OPTIONS
Focus Click the clockwise/counter-clockwise buttons to adjust the focus.
Offset Click the up/down/left/right buttons as necessary to adjust the image and make it square on the screen.
Zoom Click the buttons to automatically minimize or maximize zoom.
Copy Lens Use the Copy Lens Settings to Channel feature to easily copy the settings from the current active
Settings to channel to another channel. Select the channel from the drop-down list and click Copy to apply the
Channel changes. Repeat for every channel that requires the same ILS values.
3-30
1) If the Motorized Auxiliary Lens Mount (MALM) is present, ensure to move
Figure 3-23 Channel: Lens Menu Options
Change Icon: Click to change
icon for current channel.
Resets factory defaults.
Zoom: Minimize/Maximize.
CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)