Christie CP2000-ZX User Manual page 25

STEP 9 - Connect Sources and Initial Power Up
Once the lamp is installed, the projector is essentially ready for operation. Although an image is not required at
this time, it is recommended that external cinema servers and sources be connected. Refer to
Connecting Sources.
Before igniting the lamp for the first time, it is essential that you complete the following settings to ensure
successful communication with the projector:
1. Assign the projector with a unique IP address. Each projector is given a default IP address, however if
you are connecting the projector to an existing network you must give it a new IP address. For first time
installations, assign the IP address in the Configuration > Administrator menu via the Control Display
Panel (CDP). For more information on the CDP, refer to
(CDP).
2. Set the baud rate. In the CDP Configuration menu, set the baud rate to match the external device
connected (such as a server). The projector's default baud rate is 9600 Kbps.
3. Enter details of the lamp. In the CDP Lamp menu, select Lamp Change and define the type of lamp
installed, serial number and number of hours logged on the lamp (if any).
4. Power-up the projector. With all components installed and connected, power-up the projector as
described in
5. Perform LampLOC™ alignment immediately on the newly installed lamp. This ensures the lamp is
positioned correctly to achieve maximum light output. Refer to
instructions.
6. Perform initial optical alignment in order to optimize images displayed on screen. These adjustments
must be done before boresight adjustments. Refer to
7. Adjust optical components when needed. In rare instances, the installer may have to adjust one or more
optical components. Refer to
CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)
Section 3.2.1 Powering Up the
Section 2.9 Fold Mirror and Convergence Adjustments
Section 3.3 Using the Control Display Panel
Projector.
Section 2.5 Initial Power Up
Section 2.7 Basic Image Alignment
Section 2: Installation & Setup
Section 2.2
for
for instructions.
for instructions.
2-11