Working With The Lamp; Turning The Lamp On Or Off; Using The Web User Interface; Using The Cdp - Christie CP2000-ZX User Manual

Section 3: Operation
3.6

Working with the Lamp

Simple software controls and adjustments can help to optimize lamp performance and ensure the brightest,
most uniform image possible for the life of the lamp. These controls are located in the Advanced: Lamp and
Admin: Lamp menus. For more information, refer to
Lamp Menu, on page

3.6.1 Turning the Lamp ON or OFF

Using the Web User Interface

ON:
1. Make sure the wall circuit breaker is ON.
2. From the Main menu, select
and Douser Open. Wait several minutes for the lamp to
turn on. (Figure 3-46)
OFF:
1. De-select Lamp On. Then wait for fans to run for 10 minutes to cool the lamp and other components.
2. De-select Power On to turn the projector off.
3. Turn wall circuit breaker OFF.

Using the CDP

ON:
With the wall circuit breaker ON, press and hold the
the projector on. Then press
OFF:
Press
LAMP OFF
for 10 minutes to cool the lamp and other components completely. Then press
projector. Turn wall circuit breaker OFF to disconnect power.

If the Lamp Fails to Ignite

The projector automatically re-tries ignition after 10 seconds using 100% of the maximum power acceptable
for the lamp. If this re-try also fails, and there is no interlock problem such as an open lamp door, a new lamp is
likely needed. The power reverts back to what was originally defined in the menus by the user.
3-50
3-47. These controls are also available on the CDP.
Power On,
to ignite the lamp.
LAMP ON
. The screen goes dark, but the projector's cooling fans will keep running. Wait for fans to run
Advanced: Lamp Menu, on page
Lamp On
Figure 3-46 Turn the Lamp On Using
button for approximately 1/2 second to power
POWER ON
3-33, and Admin:
the Web User Interface
to power down the
POWER OFF
CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)