Electronic Screen Masking; Projector Configuration Files (Pcfs) - Christie CP2000-ZX User Manual

Section 2: Installation & Setup
If there are changes to the environment in the future (for example, a new screen is installed), the CP2000-ZX
should be re-calibrated. Also note that correction for proper color balance sometimes reduces overall light
output.
NOTE: Onsite MCGD files are not provided with the projector and must be created by the installer. Multiple
gamut files can be saved for use in different situations, such as when an auxiliary lens is swapped on and off
the projector. These saved gamut files are accessible from the Channel: Page 2 menu on the web user interface
or from the Edit Channel: Measured Color submenu using the CDP.

2.10.2 Electronic Screen Masking

Image edge blanking can be corrected using the masking tool for precision cropping in the web user interface
Admin: Screen menu. The effect is similar to aperture plate filing typically done for correcting images from
film projectors. NOTE: Masking adjustments are global. Multiple screen formats can be saved for use with
various sources. These saved screen formats are selectable from the Channel: Edit Channel in the web UI or
the Edit Channel: Screen Format using the CDP.

2.10.3 Projector Configuration Files (PCFs)

Numerous settings collected into a single Projector Configuration File (PCF) further control processing
variables for optimized display of specific source material. Each PCF pre-defines color space, target color
gamut, source aspect ratio (resolution), and gamma settings for a cinema or non-cinema source. Once the
collected settings are downloaded to the projector's internal memory, their PCF can be assigned to the
corresponding CP2000-ZX input connection and quickly applied by selecting it either from the CDP Channel
> PCF File option or through the web user interface Admin: Page 2 menu. No further adjustment in
processing should be required. NOTE: Scope and Flat files must be created by the installer since they are not
provided with the projector. Additionally, if the projector is to be set up for 3D operation, 3DFlat and 3DScope
files must also be created.
2-24 CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)