Adjusting Tilt And Leveling; Adjusting Tilt; Adjusting Feet/Leveling; Carrying/Moving The Projector - Christie CP2000-ZX User Manual

8. Ensure the ground connection from the UPS input to the ground stud is secure.
9. Re-attach the side panel and plug an appropriate UPS that meets the required input specifications (refer to
Section 6.4.4 UPS
10. Re-connect main power, turn on the UPS power and ensure that the projector operates normally.
2.4

Adjusting Tilt and Leveling

from tipping forward while being adjusted for tilt or when the optical auxiliary lens is
installed.
not yet needed.
For an ideal installation, the CP2000-ZX lens surface should be centered and parallel to the theatre screen. This
orientation helps to ensure optimized lens performance with minimal offset. Choose a sturdy mounting surface
that allows for this. If this position is not possible (such as when the projector is significantly higher than the
center of the screen), it is better to rely on offset rather than extra tilt.

2.4.1 Adjusting Tilt

Important! For best optical performance, avoid tilting the projector excessively. Use vertical offset of the
lens instead.
Check with theatre personnel for the degree of screen tilt or measure this incline with a protractor at the screen.
Tilt the projector to match the screen tilt angle by extending or retracting the projector's four adjustable feet.
NOTE: The front-to-back tilt of the projector must not exceed 15°. This limit ensures safe lamp operation and
proper position of the liquid cooling reservoir in the projector.

2.4.2 Adjusting Feet/Leveling

To adjust the height or level of the projector, extend or retract the adjustable
feet located on the bottom of the projector by rotating them. Once the
required adjustment is made, tighten the lock nut. See Figure 2-19. NOTE:
Make sure the projector's rear safety strap is in place before adjusting.

2.4.3 Carrying/Moving the Projector

and hand-carry one projection head a short distance. It is
strongly recommended the projector be kept as level as possi-
ble when carrying up stairs or lifting it onto a table.
ing or carrying the projector. Avoid tilting the projector on the
right side. This can introduce an air bubble within the coolant hoses that can lead to an air
lock.
CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)
Input) into the IEC connector on the auxiliary panel.
Use of the supplied safety strap is MANDATORY to prevent the projector
Disconnect the projector from the AC for these initial alignments. Images are
Four or more people are required to safely lift
Keep the projector as level as possible when lift-
Section 2: Installation & Setup
Figure 2-19 Adjust Feet
2-15