How The Projector Works; User Interface Overview; List Of Components; Software Requirements - Christie CP2000-ZX User Manual

1.3.2 How the Projector Works

The CP2000-ZX accepts a variety of cinema or DVI-compatible "non-cinema" signals for projection on front
screens typical in commercial theatre or other large screen applications. High-brightness light is generated by a
short arc Xenon lamp, then modulated by three Digital Micromirror Device (DMD) panels responding to
incoming data streams of digitized red, green and blue color information. As these digital streams flow from
the source, light from the responding "on" pixels of each panel is reflected, converged and then projected to the
screen through one or more front lenses, where all pixel reflections are superimposed in sharp full-color
images.

1.3.3 User Interface Overview

The CP2000-ZX incorporates two basic user interface systems: the Control Display Panel and the Web User
Interface.
The Control Display Panel (CDP) is a simple keypad with a small alphanumeric LCD display panel that can be
backlit for easy viewing in dark projection rooms. It is used for a simple setup, local control of power, lamp
douser control, channel selection, lamp installation and alignment, etc.
The Web User Interface is a Web-based interface produced internally by the projector, but displayed and
controlled by a Web-based browser on a remote, local area Ethernet network or at a distance over internet
protocol. The Web User Interface is a full function setup and diagnostic tool that can be set up via a wireless
Ethernet connection for easy data entry and calibration from the theatre auditorium where the color
measurements are taken.

1.3.4 List of Components

Make sure you have received the following components with your projector:

Projector with Control Display Panel (CDP)
 Lens plug
 Nylon safety strap with clip
 Warranty Card
 Web Registration Form

1.3.5 Software Requirements

DLP version 14 series or higher
Projector Control Module (PCM) version 2.2 or higher
CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)
(required for shipping when lens is not installed to prevent contamination of critical optical components)
(required to secure projector to tabletop or optional rack mount)
Section 1: Introduction
1-5