Christie CP2000-ZX User Manual page 18

Section 2: Installation & Setup
STEP 4 - (Optional) Mount the Control Display Panel
The projector is shipped with the Control Display Panel (CDP) fully assembled
and installed to the back panel. For convenience, the display angle of the CDP
can easily be modified for improved viewing or it can be removed and
permanently mounted in another location within the projection room. NOTE:
The CDP is not recommended for use as a handheld remote.
To modify the CDP display angle:
1. Place your hand under the bottom edge of the CDP and pull forward to the
desired angle. Keep the back tab of the CDP fully engaged in the projector.
See Figure 2-2.
To remove the CDP for installation in another location:
1. Grasp the CDP and slightly push it to one side. This creates a gap sufficient enough to release the CDP
from the top mounting pin on that side. Then release the other side and pull forward to remove. See Figure
2-3.
2. When installing the CDP in a new location, be sure to keep the distance between the projector and the CDP
within 6 ft (the max. length of the standard CDP harness). See Figure 2-4.
NOTE: An optional 25ft CDP harness kit is available if more length is required (P/N 108-283101-01).
2-4
Figure 2-3 Remove CDP
Figure 2-4 CDP Mounting
Figure 2-2 Change
Display Angle of CDP
CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)