3.4.3 Main Menu
NOTE: This top tool bar appears
on all web user interface screens.
Level 1 Menus.
Source Buttons -
selected source
is highlighted.
Icon for current
setup.
Additional sources
(64 sources total).
Power ON or OFF
Enable Power On to enter STANDBY mode. Power to projector components is present. Deselect checkbox to
turn power OFF.
Turn the Lamp ON or OFF
Enable Lamp On to turn the lamp ON. If an error exists, which will not allow the lamp to turn ON, the button
will be greyed out. Deselect checkbox to turn the lamp OFF.
Open or Close the Douser (Shutter)
Enable Douser Open to open the douser. Deselect checkbox to close the douser.
Display a Test Pattern
Enable Test Patterns to display the set of test patterns pre-selected from the Advanced: Test Pattern menu. If
more than one test pattern is programmed, selecting it again obtains the next test pattern in the sequence. To
return to the program, select a Channel button again.
Move the Auxiliary Lens
Toggle the current location of the optional motorized auxiliary lens mount; position it either in front of the
primary lens (enable Auxiliary Lens checkbox), or move it out (disable Auxiliary Lens checkbox).
CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)
Current projector displayed.
Use the drop-down to display a
list of available projectors.
Drop-down list icon.
Figure 3-8 Main Menu
Real time clock.
Exit.
Status Indicator: Green = OK,
Yellow = Warning, Red = Critical
Error (Alarm Condition exists).
Turn Projector Power ON / OFF.
Turn Lamp ON / OFF.
Open or Close Douser (shutter).
Enable Test Patterns.
Enable/disable Auxiliary Lens.
Enable / Adjust Intelligent Lens Sys-
tem (ILS)
Section 3: Operation
3-15