Section 1: Introduction
1.1
Using this Manual
/
USERS
OPERATORS
brightness projection systems located in restricted areas such as projection rooms in theatres. Such users may
also be trained to replace the lamp and air filter, but cannot install the projector or perform any other functions
inside the projector.
: Only trained and qualified Christie service technicians knowledgeable about all potential hazards
SERVICE
associated with high voltage, ultraviolet exposure and high temperatures generated by the lamp and associated
circuits are authorized to 1) assemble/install the projector and 2) perform service functions inside the projector.
This manual contains the following sections:
•
Section 1 Introduction
•
Section 2 Installation & Setup
•
Section 3 Operation
•
Section 4 Maintenance
•
Section 5 Troubleshooting
•
Section 6 Specifications
•
Appendix A: Serial API
•
Appendix B: SCCI Port
•
Appendix C: GPIO
•
Appendix D: CDP Error Codes
Disclaimer: Every effort has been made to ensure the information in this document is accurate and reliable. However, due to ongoing
research, the information in this document is subject to change without notice. Christie Digital Systems assumes no responsibility for
omissions or inaccuracies. Updates to this document are published regularly, as required. Please contact Christie Digital Systems for
availability.
1.1.1 Typographical Notations
The following notations are used throughout this manual:
• Keypad commands and PC keystrokes appear in bold small caps, such as
• References to specific areas of the document appear italicized and underlined. When viewed online the text
appears in blue indicating a direct link to that section. For example,
Section 6
Specifications.
• References to other documents appear italicized and bold, such as Christie Service Manual.
• References to software menus and available options appear bold, such as Main Menu, Preferences.
• User input or messages that appear on screen, in status display units or other control modules appear in
Courier font. For example. "No Signal Present", Login: christiedigital.
• Error codes, LED status appear in bold, e.g.
• Operational states of modules appear capitalized, such as "power ON, power OFF".
• Signal words, such as Warning, Caution and Notes are used in this manual to point the reader to specific
information or instructions that warn of safety related hazards which may be present and indicates how to
avoid them.
1-2
: This manual is intended for trained users authorized to operate professional high-
LP, A1 etc.
,
,
etc.
POWER
INPUT
ENTER
CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)