Christie CP2000-ZX User Manual page 141

Lamp Intensity (LPI)
DESCRIPTION - Set lamp intensity set point. The value is used when lamp mode is set to LiteLOC™. The projector will
adjust the Lamp Power to maintain this intensity. NOTE: This control depends on the state of the Power Per Button (PPB) con-
trol. When PPB is on, the lamp hardware will be set according to the channel specific value of LPI. When PPB is off, the lamp
hardware uses the global (GLOB) value for LPI.
SUBCODE DESCRIPTION OF USE
Cxxx Replace xxx with the channel number. Valid Range is 101 - 164.
GLOB Set lamp intensity for all channels when PPB is off.
NONE Set lamp intensity for the current channel.
EXAMPLES:
(LPI+GLOB 4500) Set lamp intensity to 4500 for global
(LPI+C101 4500) If channel 101 active, same as (LPI 4500)
(LPI+C102 4500) If channel 102 INactive, set lamp intensity to 4500 for channel 102, regardless of PPB.
(LPI+GLOB 4500) Set lamp intensity to 4500 for global. All channels with PPB off will use this value. If current channel's PPB
is off, the lamp will adjust immediately.
(LPI+C108?) Get lamp intensity for channel 108, regardless of PPB
Lamp Life (LPL)
DESCRIPTION - Set or get expected lamp life in hours. The default hours will be used if lamp life is 'not set'. Lamp expiry
message will be sent out when lamp usage is over the lamp life.
SUBCODE DESCRIPTION OF USE
LIFE 0 - No warning will be generated. 1 - Lamp Life Expiry Warning will be generated when lamp hours
extends past lamp life. Warning will be reported in SST. Warning will be cleared by extending lamp life or
changing the lamp.
None Set or get expected lamp life.
ROTA Set to 1 acknowledge the Lamp Rotation Warning. Will auto clear at lamp life or on lamp change.
ROTW 0 - No warning will be generated. 1 - Lamp Rotation Warning will be generated when lamp hours extents
past 1/2 lamp life. Warning will be reported in SST. Warning will be cleared by LPL+ROTA or changing
the lamp.
EXAMPLES:
(LPL 1500) Set lamp life limit to 500 hours
(LOL 0) Set lamp life limit to default hours based on the lamp type
(LPL ?) Get lamp life limit
(LPL+LIFE 1) Enable lamp expired message.
(LPL+LIFE 0) Disable lamp expired message.
(LPL+ROTW 1) Enable lamp rotation message.
(LPL+ROTA 1) Acknowledge that lamp was rotated.
CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)
Appendix A: Serial API
A-13