Copy The Channel Settings To Another Channel; Add Anamorphic Lens; Wide Converter Lens - Christie CP2000-ZX User Manual

Section 2: Installation & Setup

2.8.4 Copy the Channel Settings To Another Channel

Once the basic image alignment for a channel is complete, you can copy this setting between channels.
• From the Channel: Lens menu, use the drop-down menu to select a particular channel and click Copy for
the changes to affect the selected channel. Repeat for every channel that requires the same ILS values.

2.8.5 Add Anamorphic Lens

1. Install the Auxiliary Lens Mount according to instructions provided in the kit. Make sure to optimize your
primary lens first for best optical alignment, offset and boresight.
2. Image geometry distortion: Loosen the holding clamp on the auxiliary lens mount. Adjust the rotation of
the anamorphic lens so the image remains perfectly square with anamorphic in and out.
3. Image shift: Adjust the location of the anamorphic lens so that the image does not shift left or right with
the anamorphic lens in and out.
4. Vignetting: Adjust the location of the anamorphic lens so the image passes through the center as much as
possible without vignetting, reducing side or corner brightness, especially in wide angle projection.
5. Focus primary lens: With the anamorphic lens not in place, re-focus the primary lens using the
knob. The goal is for good focus at the center and on all sides. Now add the anamorphic lens and check
focus again.
6. Focus anamorphic lens: If center-to-edge horizontal focus in the image needs improvement, focus the
anamorphic lens by rotating its focus barrel as needed.

2.8.6 Wide Converter Lens

1. Install the Auxiliary Lens Mount and Wide Converter Lens (WCL) according to instructions provided in
the kit. Make sure to optimize your primary lens first for best optical alignment, offset and boresight.
2. Image shift: Adjust the vertical and horizontal position of the WCL to align it with the already adjusted
prime lens.
3. Pitch Adjustment: Adjust pitch, either up or down to equalize the top and bottom clearance to the prime
lens barrel.
4. Yaw Adjustment: Adjust yaw to make the clearance between both lens barrels equal from side-to-side.
2-22
Figure 2-29 Copy Channel Settings
FOCUS
CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)