Connecting Sources - Christie CP2000-ZX User Manual

Section 2: Installation & Setup
2.2

Connecting Sources

Cinema servers, such as digital media storage devices or non-cinema sources such as PCs reside outside the
projector and are connected to one of the ports on the Projector Control Module (PCM) located on the right
hand side of the projector.
These communication ports are accessible by first removing the side access panel. When connecting sources or
servers, route all cables along the channel ways located on the bottom of the projector and up through the
opening in the frame to the communication connection port.
In most cases, it is recommended the access panel be replaced to ensure server and source connections remain
secure. NOTE: 1) To maintain radiated emissions compliance, do not connect I/0 cables to the projector
without connecting the source or receiver at the other end. 2) Right angle (75 Ohm) BNC adapters are
provided which can be used when connecting to the 292A and 292B ports. This directs source cables
downward and enables full closure of the PCM cover.
Figure 2-16 Connecting an External
2-12
(optional)
Cinema Server/Source
PWR CPU
Connect to
AC at site
Figure 2-16 Connecting Non-Cinema
PWR
Connect to
AC at site
Servers/Sources
CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)
CPU