The Display Is Faint; The Upper Portion Of The Display Is Waving, Tearing Or Jittering; Portions Of The Display Are Cut Off Or Warp To The Opposite Edge; The Display Appears Compressed (Vertically Stretched) - Christie CP2000-ZX User Manual

Section 5: Troubleshooting

5.6.3 The Display is Faint

1. The source may be double terminated. Ensure the source is terminated only once.
2. The source (if non-video) may need sync tip clamping.

5.6.4 The Upper Portion of the Display is Waving, Tearing or Jittering

This can sometimes occur with video or VCR sources. Check your source.

5.6.5 Portions of the Display are Cut Off or Warp to the Opposite Edge

Resizing may need adjustment. Adjust until entire image is visible and centered.

5.6.6 The Display appears Compressed (Vertically Stretched)

1. The frequency of the pixel sampling clock is incorrect for the current source.
2. Sizing and positioning options may be adjusted poorly for the incoming source signal.
3. Use an anamorphic lens for typical HDTV and anamorphic DVD sources that have been re-sized and
vertically stretched via 3rd-party software.

5.6.7 Data is Cropped from Edges

To display the missing material, reduce image size to fill the display area available in the projector, then stretch
vertically to fill the screen from top to bottom. Add the anamorphic lens to regain the image width.

5.6.8 Display Quality appears to Drift from Good to Bad, Bad to Good

1. The source input signal may be of low quality.
2. The H or V frequency of the input may have changed at the source end.

5.6.9 The Display has Suddenly Froze

If the screen blacks out inexplicably, it is possible that excessive voltage noise on the AC or ground input has
interrupted the projector's ability to lock on to a signal. Power down the projector and then power back up
again.

5.6.10 Colors in the Display are Inaccurate

The color, tint, color space and/or color temperature settings may require adjustment at your input source, or on
the web user interface Channel > Page 2 setup menu. Ensure the correct PCF, TCGD and/or Color Space file
for the source is used.

5.6.11 The Display is Not Rectangular

1. Check leveling of the projector. Ensure the lens surface and screen are parallel to one another.
2. Is the vertical offset correct? Adjust as necessary using the vertical offset knob.
3. Is the anamorphic lens straight? Rotate to orient aperture correctly.
5-6 CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)