Work With Lenses; Access The Ils; Enable Ils On A Channel; Alter The Active Ils Settings - Christie CP2210 User Manual

5.6

Work with Lenses

The lens mount secures the primary zoom lens to the projector and provides setup adjustments for correct
boresight, and manually controlled focus, zoom and offsets. See
installation and boresight instruction.
An anamorphic lens (1.25x) can be installed into the optional motorized auxiliary lens mount, then adjusted
into place in front of the primary lens to widen a "squeezed" image into a properly proportioned "scope"
anamorphic cinema display. It is typically used in theatres having side masks that are retracted for "scope"
images, or in theatres having fixed side masking but a very short throw ratio.

5.6.1 Access the ILS

On the Main screen of the TPC, tap Advanced Setup > ILS File Setup.

5.6.2 Enable ILS on a Channel

1. On the Main screen of the TPC, tap a channel.
2. Tap the Test Patterns button and then tap a test pattern.
3. On the Main screen of the TPC, tap Lens Adjust.
4. Tap Enable Automatic ILS to automatically apply the active channel settings.

5.6.3 Alter the Active ILS Settings

1. On the Main screen of the TPC, tap Lens Adjust.
2. Tap Enable Automatic ILS.
3. Tap the directional arrows to adjust the values displayed in the X, Y, and Zoom fields. These values over-
write the ILS settings.

5.6.4 Maintain Lens Position Regardless of Selected Channel

1. On the Main screen of the TPC, tap Lens Adjust.
2. Clear the Enable Automatic ILS check box.
CP2210 User Manual
020-100410-07 Rev. 1 (01-2012)
Downloaded from ProjectorsManual.com Manuals
Vertical Boresight Adjust
Horizontal
Boresight
Adjust (Right)
Figure 5-1 Lens Mount
Section 3: Operation
Section 4.3 Basic Image Alignment
Lock/Unlock Clamp
Horizontal
Boresight
Adjust (Left)
for all lens
5-5