Enable Ils On A Channel; Alter The Active Ils Settings; Maintain Lens Position Regardless Of Selected Channel; Reset The Ils - Christie CP4230 User Manual

Section 5: Cinema Projector Operation

5.7.4 Enable ILS on a Channel

1. On the Main screen of the TPC, tap a channel.
2. Tap the Test Patterns button and then tap a test pattern.
3. On the Main screen of the TPC, tap Lens Adjust.
4. Tap Enable Automatic ILS to automatically apply the active channel settings.

5.7.5 Alter the Active ILS Settings

1. On the Main screen of the TPC, tap Lens Adjust.
2. Tap Enable Automatic ILS.
3. Tap the directional arrows to adjust the values displayed in the X, Y, and Zoom fields. These values over-
write the ILS settings.

5.7.6 Maintain Lens Position Regardless of Selected Channel

1. On the Main screen of the TPC, tap Lens Adjust.
2. Clear the Enable Automatic ILS check box.
3. Tap OK.
4. Adjust the focus, Horizontal (X) and Vertical (Y) offset, and zoom by tapping the applicable button.
NOTE: This does not over-write the system settings for the ILS. If
the ILS will position the lens to the saved channel settings.
5. If the
Quick Reset
lens returns to this remembered location. Also, this setting is remembered across system resets and reboots.

5.7.7 Reset the ILS

The ILS must be reset when:
• the lens has been moved
• manual adjustments have been made to horizontal or vertical offset, zoom or focus
• a power outage occurred during a channel change
• ILS settings are drifting within a short period of time
1. On the Main screen of the TPC, tap Lens Adjust.
2. Tap Quick Reset. If Enable Automatic ILS is not selected, the lens returns to the stored settings.

5.7.8 Calibrate the ILS

You must calibrate the ILS must when you install a new lens.
1. On the Main screen of the TPC, tap Lens Adjust.
2. Tap Full Calibration. If Enable Automatic ILS is not selected, the lens returns to the stored settings.
5-8
or buttons are tapped in the Advanced Setup: Lens Setup window, the
Lens Calibration
is selected again,
Enabled Automatic ILS
CP4230 User Manual
020-100621-03 Rev. 1 (05-2014)