Inserting An Avaya X330Stk Stacking Module - Avaya G700 Installing Manual

Inserting an Avaya X330STK Stacking Module

G700 Media Gateways can be mounted in equipment stacks with routers, switches, or other
G700s. The stack is limited to ten elements. To link multiple units, each G700 must be equipped
with an Avaya X330STK Stacking Module, which is mounted through the rear panel (back view)
of the G700.
!
CAUTION:
The Stacking Sub-Module is not hot-swappable. That is, the G700 must be
CAUTION:
powered off before you insert or remove a Stacking Module. If there is an active
S8300 present, the S8300 should be shut down by pressing the Shutdown
button. Hold the button in 2–3 seconds until the OK to Remove LED starts
flashing. When the LED turns on steady, power can be safely turned off.
To insert an Avaya X330STK Stacking Module
1. Remove the blank plate from the back of the G700.
2. Insert the Avaya X330STK Stacking Module gently in the bay in the back of the G700,
ensuring that the metal base plate is aligned with the guide rails.
Figure 14: Insert Stacking Module in G700 (back view)
3. Press the Avaya X330STK Stacking Module in firmly until the connector at the back of the
module is completely inserted into the internal connector on the G700.
4. Tighten the screws on either side of the module.
At this point, the required modules and cabling units have been inserted into the G700 Media
Gateway. The next step will be to install cabling.
indcsnmp KLC 042304
About installation and cabling
X330STK
Cable to lower unit Cable to lower unit
Issue 9.1 June 2006 111