Video Trigger Level Amplitude - Agilent Technologies ESA-E Series Programmer's Manual

Front Panel
Access:

Video Trigger Level Amplitude

:TRIGger[:SEQuence]:VIDeo:LEVel <ampl>
:TRIGger[:SEQuence]:VIDeo:LEVel?
Specifies the level at which a video trigger will occur.
Factory Preset
and *RST:
Range:
Default Unit:
Remarks:
Trigger Delay is not available in Video trigger mode, so turning Video
NOTE
on turns off Trigger Delay, but preserves the value of Trigger Delay.
Front Panel
Access:
Chapter 5
As the TV standard is changed, the current line value is
clipped as necessary to keep it valid for the chosen
standard and field mode. For example, line 600 is
selected in Entire Frame mode in PAL-N; if NTSC-M is
selected, the line number is clipped to 525. Or, if line
313 is selected in Field 1 mode in PAL-N and NTSC-M
is selected, the line number is clipped to 263. Changing
back to the PAL-N standard will leave the line number
at 263.
Trig, TV Trig Setup, Standard, NTSC-M
Trig, TV Trig Setup, Standard, NTSC-Japan
Trig, TV Trig Setup, Standard, PAL-M
Trig, TV Trig Setup, Standard, PAL-B,D,G,H,I
Trig, TV Trig Setup, Standard, PAL-N
Trig, TV Trig Setup, Standard, PAL-N Combin
Trig, TV Trig Setup, Standard, SECAM-L
2.5 divisions below reference level
10 display divisions below reference level to reference
level
current amplitude units
Video is adjusted using this command, but must also be
selected using the command
:TRIGger[:SEQuence]:SOURce VIDeo. When in
FM Demod and Demod View is on, the Video Trigger
level is adjusted/queried using the command
:TRIGger[:SEQuence]:VIDeo:LEVel:FREQuency
<freq>.
Trig, Video
Language Reference
TRIGger Subsystem
5-149