Agilent Technologies ESA-E Series Programmer's Manual page 262

[:SENSe]:SWEep:TIME:GATE:LEVel?
Selects the level of the gate signal. This command is for LEVel
triggering only.
Factory Preset
and *RST:
Front Panel
Access:
Time Gate Polarity
[:SENSe]:SWEep:TIME:GATE:POLarity NEGative|POSitive
[:SENSe]:SWEep:TIME:GATE:POLarity?
Selects the polarity of the gate signal. This command is for EDGE
triggering only.
Factory Preset
and *RST:
Front Panel
Access:
Preset Time Gate
[:SENSe]:SWEep:TIME:GATE:PRESet
Presets the time-gated spectrum analysis capability.
Remarks:
Control Time Gate
[:SENSe]:SWEep:TIME:GATE[:STATe] OFF|ON|0|1
[:SENSe]:SWEep:TIME:GATE[:STATe]?
Turns time gating on or off.
Time gate cannot be turned on if external trigger delay is on.
NOTE
Factory Preset
and *RST:
Chapter 5
High
Sweep, Gate Setup, Level Setup
Positive
Sweep, Gate Setup, Edge Setup, Edge Pos Neg
This command resets gate parameters to default
values, as follows:
Gate trigger type = edge
Gate polarity = positive
Gate delay = 1 µs
Gate length = 1 µs
Gate level = high
Off
Language Reference
SENSe Subsystem
5-107