[:Sense]:Obwidth Subsection - Agilent Technologies ESA-E Series Programmer's Manual

Language Reference
SENSe Subsystem
Remarks:
Manually selecting a harmonic will remove any restrictions on Mixer
NOTE
Bias and Mixer Type, and External Mixer Band will become USER.
Returning the Harmonic to AUTO will reset the band to A, set Mixer
Type to UNPReselect, and turn Mixer Bias Off.
Front Panel
Access:

[:SENSe]:OBWidth Subsection

Set OBW Number of Averages
[:SENSe]:OBWidth:AVERage:COUNt <integer>
[:SENSe]:OBWidth:AVERage:COUNt?
Set the occupied bandwidth measurement number of averages.
Remarks:
Front Panel
Access:
OBW Averaging On/Off
[:SENSe]:OBWidth:AVERage[:STATe] OFF|ON|0|1
[:SENSe]:OBWidth:AVERage[:STATe]?
Turn on or off occupied bandwidth averaging.
Factory Preset
and *RST:
Remarks:
Front Panel
Access:
Set OBW Span
[:SENSe]:OBWidth:FREQuency:SPAN <freq>
5-100
The harmonic value with its associated sign is
automatically determined from the external mixer
band selected. This is the AUTO mode. For mixers
other than the HP/Agilent 11970-Series or
11974-Series, an LO harmonic other than that
determined in the AUTO mode may be required. This is
achieved using this command and related command
[:SENSe]:MIXer:HARMonic <value>.
Input/Output (or Input), Input Mixer, Mixer Config, Harmonic
Auto Man
This command is used for measurements in the
menu.
MEASURE
Meas Setup, Avg Number
Off
This command is used for measurements in the
menu.
MEASURE
Meas Setup, Avg Number On Off
Chapter 5