Agilent Technologies ESA-E Series Programmer's Manual page 319

Error Messages
Informational Messages
Measurement halted. Press a measurement key to
continue.
This error occurs after you choose to refrain
Cancel
from setting the attenuator to 0 dB during the Receive
Channel Power and Receive Spur measurements.
Not enough frequency range to measure
harmonics for channel.
Selected harmonics are above the frequency range of
the instrument.
Option activated
This message is displayed after entering the selected
option's License Key.
Please set RF input range (INPUT menu) to
manual first.
In order to manually set the reference level and/or the
attenuation under the front-panel key, the
Amplitude
RF Input Range menu under the front-panel key
Input
must be set to (manual).
Man
Table loaded successfully.
When the key was pressed on the second
Load Table
page of the edit table form while in the out-of-band
spurious measurement, the file was present. The
information has been loaded into the measurement
where it may be edited again by the user. This message
will also appear when the out-of-band spurious
measurement is opened if a spur table has been
previously saved.
Table saved successfully.
This message appears after the user presses the
key on the second page of the edit table for
Save Table
the out-of-band spurious measurement. It indicates
that the current spur table has been written
successfully to disk and is available to be loaded by
means of the key.
Load Table
Chapter 7 7-11