Agilent Technologies ESA-E Series Programmer's Manual page 343

207
Unable to store flatness data
A failure occurred in setting the flatness data in the
internal EEROM. Contact your local Agilent
Technologies sales and service office.
703
Unknown printer
In attempting to identify the printer, a valid response
was received but the printer is not known to the
analyzer. Use the
Setup
702
Unsupported printer
A printer which is recognized, but known to be
unsupported was identified. This printer cannot be
used with the analyzer. For example, a printer only
supported by Microsoft Windows will generate this
error.
617
Wrong density floppy inserted
The floppy disk has the wrong density. It should be
1.44 MB.
Chapter 7
printer menu under
Custom
to configure the printer.
Error Messages
201 to 799: Device-Specific Errors
Print
7-35