Agilent Technologies ESA-E Series Programmer's Manual page 318

Error Messages
Informational Messages
Default spur table values loaded.
No spur table has been previously saved when the
Out-of-Band Spurious measurement begins. Press
Setup, Edit Table
interest and press
This saved table will be loaded the next time the
measurement is run.
Device = Mobile. Code Domain not available.
Code Domain measurement is greyed out when the
device is set to mobile under the
key. Code Domain measurement is only accessible when
the device is set to base and Digital Signal Processing
and Fast Analog to Digital Converter (Option B7D) or
RF Communications Hardware (Option B7E) are
installed.
Device = Mobile. Mod Acc not available.
Modulation accuracy measurement is greyed out when
the device is set to mobile under
front-panel key. Modulation accuracy is only accessible
when the device is set to base and Digital Signal
Processing and Fast Analog to Digital Converter
(Option B7D) or RF Communications Hardware
(Option B7E) are installed.
Directory already exists
Each directory and file must have a unique name. The
directory name you have entered is currently being
used on the selected drive. You may either enter a new
name or rename the directory currently existent. Refer
to the Agilent Technologies ESA Spectrum Analyzers
User's Guide.
Entire trace is below the threshold level.
The measurement cannot operate properly because the
trace has fallen completely below the threshold level.
7-10
to enter the frequency ranges of
to save that information.
Save Table
Mode Setup
Mode Setup,
Meas
front-panel
Chapter 7