Agilent Technologies ESA-E Series Programmer's Manual page 338

Error Messages
201 to 799: Device-Specific Errors
763
Incorrect filename, allowable extensions are
.gif or .wmf
Attempt to save a screen image to a file with an
incorrect extension.
762
Incorrect filename, allowable extensions are
.trc or .csv
Attempt to save a trace to a file with an incorrect
extension.
770
Instrument mode requested is not supported
Instrument mode specified with :INST command is not
valid. Refer to Chapter 5, "Instrument Subsystem" of
Agilent Technologies ESA Series Spectrum Analyzers
Programmer's Guide for more information.
751
Instrument state may be corrupt, state has
been reset to initial values
An error in the internal instrument state has been
detected. The state has been reset to a default value.
734
Interpolation error: cannot compute log of
<negative_frequency_value>
Occurs when the frequency interpolation of a limit line
is set to log and the start frequency of the instrument is
negative. The <negative_frequency_value> is limited to
– 80 MHz, so it may not match the frequency that
caused the error.
216
Invalid Baud Rate
Attempt to use invalid baud rate. Refer to Chapter 5,
"Instrument Subsystem" of Agilent Technologies ESA
Series Spectrum Analyzers Programmer's Guide for
more information.
7-30 Chapter 7