Agilent Technologies ESA-E Series Programmer's Manual page 335

219
Command not valid in this model
Indicates that the command sent from the remote
interface does not apply to this model number. For
example, attempting to center the preselector in an
analyzer without a preselector will generate this error.
222
Command not valid when no measurement is
active
Indicates that the command sent from the remote
interface must be issued while a measurement is
running in the analyzer. .
772
Cannot load a directory, please choose a file
You have selected a directory instead of a file when
attempting to perform the Load function under the
front-panel key.
652
Connect Amptd Ref Output to Input
For Agilent Technologies E4402B, E4403B, E4404B,
E4405B, E4407B, and E4408B only: you must connect
the
AMPTD REF OUTPUT
appropriate cable.
651
Connect RF OUT to INPUT
Attempt to align the tracking generator without its
output connected. Connect the tracking generator RF
OUT to the analyzer
615
Corrupted file
The file that you were trying to load is corrupt.
610
File access is denied
The file is protected or hidden and cannot be accessed.
604
File already exists
Attempt to save to a file that already exists. Delete or
rename the old file and try again.
Chapter 7
201 to 799: Device-Specific Errors
to the analyzer
INPUT
.
INPUT
Error Messages
File
with the
7-27