Agilent Technologies ESA-E Series Programmer's Manual page 341

223
Trigger Offset unavailable in swept spans
Trigger Offset is only available in Zero Span. (Refer to
the Agilent Technologies ESA Spectrum Analyzers
User's Guide.)
215
TG start freq is less than 1/2 res bw
TG uncalibrated at start frequencies below 1/2 the
current resolution bandwidth.
214
TG start freq is less than 9kHz
TG uncalibrated below 9 kHz.
204
TG Frequency Limit
The tracking generator has reached the limit of its
allowable frequency range.
736
Too many data values at <freq_or_time_value>
This message may appear when data is sent to a
corrections or limit table using the
commands. These tables limit the number of
amplitudes associated with a frequency or time to 2 or
less. This message will appear if an attempt is made to
attach 3 or more values to a frequency or time.
206
Unable to initialize flatness data
A failure occurred in setting the flatness data in the
internal EEROM. Contact your local Agilent
Technologies sales and service office.
762
Unable to load file
A failure occurred while loading a file; the file was not
loaded.
759
Unable to load state saved from firmware
Rev A.03.00
A saved state file from a newer firmware revision was
attempted to be loaded into an older instrument.
Chapter 7
Error Messages
201 to 799: Device-Specific Errors
or
DATA MERGE
7-33