Figure 2-53 Trigger Level Pop-Up - Agilent Technologies N1911A User Manual

2 General Power Meter Functions
For N1912A, by pressing
N O T E
different softkeys:
Mode
To change the setting press
The current setting is displayed below the label. When
you can choose the RF power level transition used as the trigger. The
power meter automatically finds a triggering power level transition when
AutoLvl
Level
The current value is shown below the
level you can enter is limited to 40 dB below the maximum sensor power.
To change the setting press
the required value in the Trigger Level pop- up window to enter the new
value.

Figure 2-53 Trigger Level pop-up

Complete the entry by pressing
Delay
time is applied between the trigger event and all the gate start times. This
allows you to time- shift all the gates by the same amount with one setting
change. A delay of up to 1 second can be entered. To enter or change the
setting press
value in the Trigger Delay pop- up window to enter the new value.
68
Source
Ext Ch.A
,
Mode
The key is only available when trigger
is selected.
Level
is only available when
The current setting is displayed below the
Delay
and use the numeric keypad to enter the required
, you can choose your source through the three
Ch.B
, and .
Mode
and choose
Norm
trigger mode has been selected.
Level
label. The minimum power
Level
and use the numeric keypad to enter
dBm
.
N1911A/1912A P-Series Power Meters User's Guide
Source Int
is selected.
Norm AutoLvl
or .
Norm
is selected
Delay
label. The delay