Set Tv Field Mode - Agilent Technologies ESA-E Series Programmer's Manual

Language Reference
TRIGger Subsystem
Remarks:
Trigger Delay is not available in Free Run, so turning Free Run on
NOTE
turns off Trigger Delay, but preserves the value of Trigger Delay.

Set TV Field Mode

:TRIGger[:SEQuence]:TV:FMODe ENTire|ODD|EVEN
:TRIGger[:SEQuence]:TV:FMODe?
This command allows the user to determine how the fields of the TV
picture signal will be treated by the trigger system.
Factory Preset
and *RST:
Range:
Refer to chapter 6, Front-Panel Key Reference, in the Agilent ESA
NOTE
Spectrum Analyzers User's Guide for a more detailed explanation of TV
fields and command dependencies.
Front Panel
Access:
5-146
Free-run activates the trigger condition that allows the
next sweep to start as soon as possible after the last
sweep.
ENTire (entire frame)
ENTire (entire frame)
For formats NTSC-M, NTSC-Japan, and PAL-M, the
minimum line is 1, and the maximum line is 525.
For formats PAL-B, D, G, H, I, PAL-N, PAL-N Combin,
and SECAM-L, the minimum line is 1, and the
maximum line is 625.
ODD (Field 1)
For formats NTSC-M, NTSC-Japan, and PAL-M, the
minimum line is 1, and the maximum line is 263.
For formats PAL-B, D, G, H, I, PAL-N, PAL-N Combin,
and SECAM-L, the minimum line is 1, and the
maximum line is 313.
EVEN (Field 2)
For formats NTSC-M, NTSC-Japan, and PAL-M, the
minimum line is 1, and the maximum line is 262.
For formats PAL-B, D, G, H, I, PAL-N, PAL-N Combin,
and SECAM-L, the minimum line is 1, and the
maximum line is 312.
Trig, TV Trig Setup, Field, Entire Frame
Trig, TV Trig Setup, Field, Field One
Trig, TV Trig Setup, Field, Field Two
Chapter 5