Status:questionable Registers - Agilent Technologies ESA-E Series Programmer's Manual

Status Registers
Use Status Registers to Determine the State of Analyzer Events and Conditions
Figure 2-12
15
Bit Number
Operation

STATus:QUEStionable Registers

STATus:QUEStionable registers monitor the overall analyzer
condition. They are accessed with the :STATus:OPERation and
:STATus:QUEStionable commands in the :STATus command
subsystem.
The STATus:QUEStionable registers also monitor the analyzer to see if
there are any questionable events that occurred. These registers look
for anything that may cause an error or that may induce a faulty
measurement. Signs of a faulty measurement include the following:
• hardware problems
• out of calibration situations
• unusual signals
All bits are summary bits from lower-level event registers. (For a
NOTE
general diagram of the STATus:QUEStionable register, see
on page 2-21.)
2-20
14 13 12 11 10 9
STATus:OPERation:ENABle <num>
STATus:OPERation:ENABle?
Status Event Enable Register
8 7 6 5 4 3 2 1 0
ck767a
Figure 2-13
Chapter 2